Using the Dial via SIP Functionality

Both the IceWarp Outlook Sync and IceWarp WebClient have the ability to dial out via SIP clients.

In the IceWarp Outlook Sync

• Locate and select the contact you wish to call (if the person you wish to call is not in your contacts skip this step)
• Select "Dial via IceWarp Server" from the IceWarp Outlook Sync dropdown menu.
• Check the correct contact is displayed and click Dial
• Your SIP client will start to ring, answer it.
• After a couple of seconds the other person's SIP client will be contacted and your conversation can start.

In IceWarp WebClient

• Click "Dial" on the menu bar.
• Select the Contact you wish to call (or type in the email address) and click Dial.
• Your SIP client will start to ring, answer it.
• After a couple of seconds the other person's SIP client will be contacted and your conversation can start.

Note that the call is in no way routed by IceWarp Outlook Sync or IceWarp WebClient, they are just used to initiate the call. The SIP server dials your registered client and once connected route the call to the destination you specified. This method will work with any SIP client.